GSC Power-Division Beehive springs feature some of the most impressive manufacturing techniques in the industry. Our beehive spring uses an ovate wire which utilizes advanced material heat treatment methods for superior load loss capabilities. What this means to you is our spring has the highest level of spring load retention while still maintaining good fatigue threw out the life of the spring.
The retainer side of the valve spring has a smaller diameter to greatly reduce coil spring surging and improve valve control even at extreme rpm levels.
Only the best materials go into the GSC Power-Division Beehive valve springs. Each batch is scrutinized for tensile strength properties, ductility, inclusion content, and fatigue toughness. Each new design is tested to 11,000RPMS so you can rest assure that you have the best possible valve spring set available on the market.
GSC Single Beehive valve spring sets, include new 4340 Chro-molly spring seats (these won't crack like others aluminum seats) and Titanium Retainer set. This kit is capable of 11000+ RPMS, with as much as 12.5mm of lift. This is a must have for anyone pushing the limits. If you have had problems with valve float or throwing rocker arms this is the spring set that will cure your problems for good...
Seat at 1.46"= 95 pounds
.300"= 200 pounds
.400"= 250 pounds
Please Note: This set requires the use of the factory valve locks.